ESI Waveterminal 192 Spécifications télécharger pdf (Page 21)

ESI Waveterminal 192

5. Connection with external device - Waveterminal 192L

Caution: This chapter is for Waveterminal 192L only

Basically, Waveterminal 192L is a digital audio interface with analog 2 channel (stereo)

input, 1 Mic channel(mono) input, analog 6 channel output and Digital stereo Optical

output.

Also with optional add-on card MI/ODI/O add-on card, you can add SPDIF Optical

Input, SPDIF Coaxial In/Out and 1 In/1 Out MIDI interface.

1. Waveterminal 192L Input/Output

Waveterminal 192L consists of analog 2 channel Input, one Mic input & 6 channel

output and Digital Optical output.

Waveterminal 192L has total of 5 connectors composed of TRS(Tip/Ring/Sleeve)

connectors.

MIC input is Balanced type input. So you need to use general Balanced Mic cable.

And Line input is stereo input port, which accepts stereo input using stereo cable.

Other 3 connectors are configured as stereo output connectors. In other words, you

should use stereo cables to these connectors and you can get 6 channel analog outputs.

Basic theory of connection cable

Waveterminal 192L’s 5 analog connectors use TRS type connectors which is devided by

three connection points and called Tip(+)/Ring(-)/Sleeve(GND). This TRS used in two

different ways.

- Stereo connector: Tip(+)/Ring(-)/Sleeve(GND) are left, right and ground. Using stereo

cable, send 2channel signal. It’s Unbalanced connection.

- Balanced connector: Three parts are Hot(+), Cold(-) and GND(Ground). This is for

Mono channel.

The point is that using one cable, 2channel flows or 1 channel flows.

Waveterminal 192L’s MIC input port is mono.

And Line in/outputs are stereo.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 53 54

Pas de commentaire

ESI Waveterminal 192 Spécifications Page 21