ESI Waveterminal 192 Spécifications télécharger pdf (Page 33)

ESI Waveterminal 192

8. OUT/MME –Output Level Adjust fader

1. OUT 1,2 3,4 5,6 – When you don’t use input monitoring.

Output goes to Output port 1,2 3,4 5,6 directly as you set on your application.

Click and drag to change Level. The numbers of bottom show the relative amount of

level in dB. If you click, it changes to ‘MUTE’.

2. OUT 1,2 3,4 5,6 – When you use input monitoring

1,2: Wave source of 1,2 as setting on your application. Also this is where you can

monitor input and it will display ‘MON’.

However Input level can’t be adjusted with this fader.

3,4: Wave source of 3,4 as setting on your application.

5,6: Output 5,6 port/fader changes to Headphone port/fader and you can monitor same

signal of Output 1,2 through 5,6. It will display ‘HP-VOL’. You can also adjust

Headphone level using this fader.

3. DIG OUT

It’s the Level meter of WT192X’s Digital output.

4. MME

You can adjust level of MME supporting software in here. MME driver output level

sometimes lower than it’s actual output level. In this case, you should adjust level using

this fader. The ‘%’ of bottom means volume level indication.

5. Mute

When you click the number on bottom of each fader, selected fader will be muted. And

the number on bottom is changed to display ‘Mute’.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 53 54

Pas de commentaire

ESI Waveterminal 192 Spécifications Page 33