ESI Waveterminal 192 Spécifications télécharger pdf (Page 17)

ESI Waveterminal 192

4. Connection with external device - Waveterminal 192X

Caution: This chapter is for Waveterminal 192X only

Basically, Waveterminal 192X is a digital audio interface with analog 2 channel (stereo)

input, analog 6 channel output and Digital stereo Optical output.

Also with optional MI/ODI/O add-on card, you can add SPDIF Optical Input, SPDIF

Coaxial In/Out and 1 In/1 Out MIDI interface.

1. Waveterminal 192X Input/Output

Waveterminal 192X consists of analog 2 channel Input & 6 channel output and Digital

Optical output.

Waveterminal 192X has total of 5 connector composed of TRS(Tip/Ring/Sleeve)

connectors. 2 analog inputs are Balanced type input and they accept mono signal.

Other 3 connectors are configured as stereo output connectors. In other words, you

should use stereo cables to these connectors and you can get 6 channel analog outputs.

Caution: You can use Balanced or Unbalanced to Waveterminal 192X’s two Inputs.

However, WT192X’s 6 Outputs always have to be used Unbalanced.

Basic theory of connection cable

Waveterminal 192X’s 5 analog connectors use TRS type connector, which is divided by

three connection points and called Tip(+)/Ring(-)/Sleeve(GND). This TRS type

connector is used in two different ways.

- Stereo connector: Tip(+)/Ring(-)/Sleeve(GND) are left, right and ground. Using

stereo cable, send 2 channel signal. It’s Unbalanced connection.

- Balanced connector: Three parts are Hot(+), Cold(-) and GND(Ground). This is for

Mono channel.

The point is that using one cable, 2channel flows or 1 channel flows.

Waveterminal 192X’s two input port are mono.

And three outputs are stereo. Its mean Outputs are 6 channel.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 53 54

Pas de commentaire

ESI Waveterminal 192 Spécifications Page 17